Malapa Air ionizer IN03

Enjoy freshly cleaned air enriched with negative ions in the rooms without being forced to use large and noisy devices for this purpose.

The IN03 air ionizer was successfully tested by the State Institute of Health. An air ionizer is a device to enrich the air with negative ions. The device is a high-performance negative ion generator and will cover even larger rooms up to 150m3. No harmful ozone was detected with the IN03 ionizer. For long-term stays in the room, we recommend staying at least 2.5m away from the device. Negative ions are fired into the space by a special carbon fiber emitter. The produced negative ions (anions) are colorless and odorless (be careful not to confuse them with ozone).

Wherever you use electrical and electronic devices, positive ions (cations) are created by the action of electrostatic charges, these cations cause increased nervousness and fatigue. This air ionizer enriches the air with negative (anions). These negative charges balance this positive charge and thus improve the breathability of the air. The device neutralizes electrostatic charges and increases the concentration of negative ions.

The ionizer is not equipped with a fan or filters that need to be replaced (no extra expenses). You can fix the device on the wall with hanging brackets (included in delivery). Long-term and error-free operation even under extreme conditions, over design.

use of ionizer:

neutralizing odors and enriching the air with negative ions in restaurants, toilets, kitchens, hospitals, homes, food stores, waiting rooms, changing rooms, department stores, low-energy buildings, relaxation rooms, salt caves, sports halls, gyms, antistatic workplaces. At home, in the food industry, industry, or in science...

measured concentrations of light negative ions:

• at a distance of 50 cm from the emitter, the average concentration of negative ions is 3.0×105 per 1 cm2
• at a distance of 100 cm from the emitter, the average concentration of negative ions is 8.0×104 per 1 cm2
• at a distance of 150 cm from the emitter, the average concentration of negative ions is 2.8×104 per 1 cm2
• at a distance of 200 cm from the emitter, the average concentration of negative ions is 1.2×104 per 1 cm2
• at a distance of 250 cm from the emitter, the average concentration of negative ions is 4.8×103 per 1 cm2
• at a distance of 300 cm from the emitter, the average concentration of negative ions is 1.3×103 per 1 cm2
• at a distance of 350 cm from the emitter, the average concentration of negative ions is 7.5×102 per 1 cm2
• at a distance of 400 cm from the emitter, the average concentration of negative ions is 5.4×102 per 1 cm2

mounting the ionizer:

The ionizer produces high voltage even with minimal current. Install the device indoors in a safe and dry place with good air circulation. The device must be placed at such a height that it is out of the reach of people and animals. The optimal distance from the device for a long-term stay of people and animals is from 2.5 m. The device must not come into contact with water or other liquids (do not use in the bathroom).

ionizer maintenance:

Always observe safety precautions during maintenance. Before handling the device, switch it off and disconnect it from the mains. The emitter (brush) can get dirty over time, you can clean it by vacuuming or scraping it (or replacing it with a new one). Do not use this product and its accessories contrary to this manual! The ionizer does not require any maintenance apart from cleaning the brush. Do not use any scouring agents or chemical solvents (paint and varnish thinners), as these agents could damage the surface. Recommended cleaning is mechanical.

technical data of the ionizer IN03:

• power supply- 230V AC 50Hz
• consumption - up to 2W
• concentration of negative ions (anions) - avg. from 3.0×105/ 1cm2 (50cm) to 5.4×102/ 1cm2 (400cm)
• ozone concentration- was not detected
• room size - up to 150m3
• main switch - with LED indication (signals connection to the electrical network)
• supply cord with fork - 3 meters
• working temperature -20° to 70°C working humidity - 10% to 70% RH (non-condensing)
• storage temperature - 0° to 45°C emitter material (brush) - carbon fibers
• emitter (brush) size - 12mm, total 31mm
• box size - length 170, width 120, height 85mm
• mounting - on the surface/ wall (bracket)
• total weight - 900 gr
• box - ABS
• protection - IPXX
• RoHS